Working temperature: -40°C~80°C
1.All into one unit, saving space and easy to move;
2.Remote control:Increase of remote control features to make the control operation more simple and convenient;
3.Environmentally: No smoke, nontoxic and peculiar smell,When diesel oil burns naturally, it will not leak and will only be discharged from the tail pipe.
4.Low noise: noise reduction processing with minimal noise;
5.Voice warning:In case of any problems happened during operation, the display window will show operators and twinkle the fault code with the voice warning the causes of problems to facilitate operators detecting and then eliminating the problems.
6.Automatic constant temperature:Automatically detect the temperature inside the car,always keep the temperature within the set range
7. low fuel consumption:With atomizing combustion device, the fuel consumption is obviously saved, the lowest gear is 0.2 liters per hour. After optimization, the power consumption of the whole machine is 40 watts after stable operation, which saves electricity very much.
8.Easy to install, economical and convenient. Can be used as a window glass defrost, but also for the cab, studio, cabin thermal insulation services.
Start the heater by pressing the "on/off" button, with a voice "welcome to use Xxx-air heater ": Press the " on/off" button for 3s to swap the air-conditioner mode or warming air mode": turn the on/off button to select the required temperature(18-45 degree) and gear (gear one to gear ten)In addition, this control switch has two operation modes: manual operation mode and automatic operation mode.
Under the manual operation mode, there are ten gears to be selected and under the automatic mode, there is a temperature range from 18℃to 45 ℃ to set up, and the switch will turn to the relevant gears in according with the cabin temperature. As the cabin temperature increases/decreases, control switch will adjust its gear positions automatically to reach the temperature set up and the heater will run in a much more intelligent and economical manner. In case of any problems happened during operation, the display window will show operators and twinkle the fault code with the voice warning the causes of problems to facilitate operators detecting and then eliminating the problems.
Turn on – When the heater is off, press the "ON/OFF " button, and with the buzzing sound, display window appears some digital number and the heater is turning on.
Turn off – When the heater is on, press the "ON/OFF” button and with the buzzing sound, the display window will appear the twinkling off with the frequency of 1Hz, suggesting the heater is turning off. When heater is off, display window blacks out and the voice tell operators "Heater is turning off, thanks for using, and have a good day."
Mode Swap – When heater is on, press the left button of "ON/OFF" to swap between manual/automatic mode. Under manual mode, there are ten gears ranging from one to ten; under the automatic mode, there is a temperature range from 18~45℃.
Turn the "ON/OFF" button in clockwise to increase the temperature and gear position and in anticlockwise to decrease the temperature and gear position.
Working Mode – Automatic operation mode: in case cabin temperature is higher than set up temperature, switch will turn to gear one automatically to make sure the heater is running with lowest gear.
In case temperature is lower than set up temperature, switch will turn to increase the one gear position if the cabin temperature is 2 degrees less than the set-up temperature and maximally to the position of gear ten.
1 x Air heater host(Knob Switch)
1 x Diesel Filter
1 x Remote control
1 x Exhaust Pipe
4 x Air Outlet Pipe
1 x Intake Pipe
1 x Installation Kit