Camera battery:
|
lithium battery
|
Camera battery:
|
3.7v 18650-1200mah
|
Light source name:
|
50*50 SMD white LED
|
Light source output
|
LED 1W
|
installation method:
|
For hoisting, wall hanging, and hoisting, hang on the handle with a chain, and hang on the melon-shaped hole behind the light box.
|
|
1. Connection method: brown wire to live wire, blue to neutral wire, yellow-green to ground (note: brown wire and blue wire cannot be connected to any switch)
|
|
2. Plug this product into AC 220V power supply (charging for 18 hours), the main power green indicator of this lamp will light up, and the LED will light up normally
|
Instructions:
|
A. Press the test switch by hand for 2S to enter the test state, the indicator light is off and the LED light is still glowing, it means that the emergency work is normal;
B. Press and hold the test switch 4S and the green indicator light 1HZ flashes to enter the monthly self-inspection simulation state, and the self-inspection passes to the main power state.
C. Probing test switch 6S green indicator light 3HZ flashes, enter the annual self-inspection simulation state, and the self-inspection passes to the main power state.
|
|
3. Normally, the fire emergency lighting is not lit, and it is lit only in emergency; in emergency state, press and hold the test switch for more than 6S to judge the emergency.
|
|
The test button is used to simulate power outage, monthly self-inspection, and annual self inspection to detect whether the emergency work of the lamps is normal. The user should perform inspection and maintenance according to the requirements of the fire protection section.
|
|
The internal power supply of the lamp is discharged from the factory. It should be charged for 24 hours before use. The charging indicator lights up during charging, and the red indicator light is off when it is nearly full. At this time, the circuit enters floating charge to charge the battery with a small current.
|
Daily maintenance:
|
Sound and light alarm 1 (fault lamp yellow light 1HZ flashing, buzzer alarm 1min/1 time), indicating that the lamp charging circuit is short-circuited or open; check the fuse or battery and repair it in time.
|
|
Sound and light alarm 2 (fault light yellow light 3HZ flashing, buzzer alarm 1min/1 time), indicating that the light source is short-circuited, open circuit or emergency circuit disconnected, check the light source or emergency circuit and repair it in time.
|
|
Sound and light alarm 3 (the yellow light of the fault light is always on, and the buzzer alarms 1min/1 time), indicating that the discharge time in the monthly self-inspection is less than 60 seconds, and the discharge time in the annual self-inspection is less than 30 minutes.
|
Battery replacement method:
|
Unscrew the mask screw, take off the panel, unplug the old battery, and connect the new battery of the same model according to the original wiring.
|
LED lamp bead replacement method:
|
Unscrew the fixing screws of the mask, take off the glass panel, and replace the new LED lamp beads of the same model.
|
Precautions:
|
The battery in the lamp can be charged and discharged more than 500 times. If you need to change the battery, you must pay attention to the polarity, voltage and capacity.
|
Reviews
There are no reviews yet.